Skip to content
Call (803) 220-0101
3625 Centre Circle, Ste C
Fort Mill, SC 29715

10News & Insights

Humidity Control Simplified: GoFog Valve Staging Racks for Air Handling Units

GoFog valve staging racks make fog humidification inside an air handling unit (AHU) easy to control and even easier to install. A PLC-based panel mounted outside the AHU sequences four motorized ball valves to produce 15 stages of humidifier output from a standard 0–10V or 4–20mA BMS demand signal.

GoFog, Inc. Product News Published Updated September 2026 2 min read

GoFog valve staging rack: a control panel with display and four selector switches above four blue motorized 3-way ball valves on stainless steel piping and a unistrut frame

How does a valve staging rack control a fog humidifier?

The atomizing nozzles inside each AHU are controlled by an external panel that contains a PLC and staging valves. The panel modulates the humidifier output based on a demand signal from the building management system (BMS), either 0–10V or 4–20mA.

When the BMS demand signal is high enough to open the first stage, the valve panel sends a pump request to the fog pump station. The pump then supplies 1,000 psi reverse osmosis water to the nozzles.

Installed GoFog staging valve rack with a control panel and four blue motorized ball valves on a stainless steel frame beside a Daikin air handling unit, with stainless tubing running into the unit

How do four valves create 15 stages of control?

The valve rack shown here uses four motorized 3-way ball valves. Each valve's discharge port feeds a manifold inside the AHU, and each manifold has a different number of nozzles. By opening the valves in different combinations, the PLC produces 15 distinct stages of capacity control, so humidifier output can closely match the BMS demand.

What features are built into GoFog staging racks?

  • Programmable stage up/down time delays prevent valve cycling.
  • An automatic flush cycle keeps fresh water in the system.
  • Optional inputs accept a high limit sensor and an air proving switch.
  • Pre-piped and pre-wired, which simplifies installation for the mechanical contractor.
  • Factory tested as a complete unit.
  • Motorized ball valves instead of solenoid valves for quiet operation.

Where are staging racks used?

One pump skid can serve staging racks on many air handlers. At the Harvard University Science and Engineering Complex, a single redundant high availability pump skid feeds motorized ball valves mounted near each AHU, each staged by the BMS. To match the panel to your site's controls standards, see GoFog Humidity Control.

Plan your AHU humidification

Contact GoFog or call (803) 220-0101 for a staging design for your air handlers.

02FAQ

Frequently asked questions

What control signal does a GoFog valve staging rack accept?

The staging rack's PLC modulates humidifier output based on a BMS demand signal of 0–10V or 4–20mA.

How many stages of control does a four-valve staging rack provide?

The valve rack uses four motorized 3-way ball valves, each feeding a nozzle manifold with a different number of nozzles. Sequencing the valves provides 15 stages of capacity control.

Why does GoFog use motorized ball valves instead of solenoid valves?

GoFog staging racks use motorized ball valves rather than solenoid valves because they provide quiet operation.

Have a project in mind?

GoFog engineers will review your application and provide a custom design and free quote.